Vintage Steam
 Products, LLC

#209 Burner Liner Material: 
High temperature resistant 310S stainless steel,  0.025" thick.  Unlike common 304 stainless which starts oxidizing at 800F, 310S will not oxidize until 2000F.  Burner liner made from this material will not crumble away with continued use.  Available only in 4 foot lengths, 6 inches wide.  Two pieces are required to line most burners with the usual 2+ inches of overlap.

#236 Vaporizer Cable:  3/16" diameter flexible stainless steel wire cable silver soldered at either end.  Custom cut to your length, sold to the nearest inch. This item is a two-part process. An $8.00 charge per cable (Step 1 - please enter quantity of cables) and an additional $0.20 per inch of cable (Step 2 - please enter the length of cable required in inches).

#237A-B Vaporizer Pipe:  1/4" schedule 40 welded stainless steel pipe used by many Stanley owners for vaporizers.  Known for its long life compared to common steel pipe.  Available in 6-1/2' and 10' lengths at Hershey, or the HCCA brass era meet in Keene, NH, or at steam car events I'm attending.  I will not ship.

#248 Boiler Lift Eyebolt:  A drop forged steel eye bolt with a 3/8" NPT thread to secure into the centrally located throttle outlet at the top of the Stanley boiler.  The 1-3/8" diameter eye leaves adequate room to attach a chain and the drop forged construction means plenty of strength for lifting even a 26" boiler.  Not recommended for boilers with the throttle hole off center which would apply a side load to the threaded connection between the boiler and the lifting eye.  For straight pulls only.  Will not fit an original boiler with 20 tpi thread, but will fit most boilers made in recent times using 3/8 NPT thread.